APPLIED ACOUSTICS SYSTEMS STRINGSTUDIO Manual do Utilizador Página 46

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 67
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 45
46 Parameters
that of the original signal. The amount of effect is determined by the ratio of wet and dry signal
mixed together as shown in Figure 29. As the amount of wet signal sent to the output is reduced, the
amount of rejection increases. The shape of the frequency of the Phaser module is also influenced
by the amount of wet signal re-injected into the feedback loop. Increasing the feedback enhances
frequency components least affected by the all-pass filter. As the feedback is increased, these peaks
become sharper. The functioning of the Phaser is very similar to that of the Flanger module. The
filtering effect is different however, since the Phaser module only introduces rejection around a
limited number of frequencies which, in addition, are not in an harmonic relationship.
0 dB
Amp
Frequency
Light effect (mix=0.1)
Medium effect (mix=0.25)
Strong effect (mix=0.5)
250 Hz 2435 Hz
Figure 29: Frequency response of a Phaser module. Effect of the mix between wet and dry signal
on the frequency response.
Tuning
The location of the first notch in the frequency response of the module is adjusted with the Fre-
quency knob This frequency can be modulated by an amount controlled with the Depth knob. In its
leftmost position, the location of the first notch is fixed but it starts to oscillate by an amount which
increases as the Depth knob is turned clockwise. The frequency of the modulation is controlled
using the the Rate knob. The feedback knob is used to fix the amount of wet signal re-injected into
the delay. Finally, the Mix knob determines the amount of dry and wet signal sent to the output.
When this knob is adjusted in the left position, only dry signal is sent to the output, in its center
position, there is an equal amount of dry and wet signal in the output and in the right position, only
wet signal is sent to the output.
Vista de página 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 66 67

Comentários a estes Manuais

Sem comentários